REMARK License Plate Frame Installation Guide

By REMARK Exhaust | Published: 2026-10-23

Category: How-to Guides

Learn how to install a REMARK License Plate Frame in minutes. Simple steps, common mistakes, and tips for a clean, secure fit on your vehicle.

Quick Answer

Install your REMARK License Plate Frame in under 10 minutes with basic hand tools—no drilling or special skills needed. Just align, secure, and check for rattles.

Why the REMARK Frame Fits Your Exhaust Setup

The REMARK License Plate Frame is designed to match vehicles equipped with REMARK exhaust systems, so it pairs visually with your aftermarket setup. Its black finish and white logo give a subtle, cohesive look without clashing with your car's styling.

Because it's a universal frame, it works with standard US-sized license plates. If you're outside the US, note that REMARK isn't liable for customs duties or taxes, and the frame is not eligible for returns or exchanges—so double-check your plate size before ordering.

Installation Steps

Gather Tools and Check Fit: You'll need a Phillips screwdriver (or socket set) and the existing screws from your current plate. Hold the REMARK frame against your plate to confirm the holes align—most standard plates fit, but verify before you start. Confirm hole alignment before tightening to avoid stripped screws.
Remove the Old Plate and Frame: Unscrew the existing plate from the vehicle. If there's an old frame, remove it and set it aside. Inspect the mounting holes for rust or debris and clean them with a cloth if needed. Clean the mounting area to ensure a snug, rattle-free fit.
Attach the REMARK Frame to the Plate: Place the frame over the plate, aligning the screw holes. Some frames have a lip that covers the plate edge—make sure it sits evenly. Insert the screws through the frame and plate, but don't tighten fully yet. Keep screws loose until the frame is centered.
Mount the Plate to the Vehicle: Position the plate and frame assembly against the vehicle's mounting points. Insert the screws and tighten them snugly—avoid over-tightening, which can crack the frame or strip the threads. Use a torque of just finger-tight plus a quarter turn.
Check for Rattles and Alignment: Give the frame a gentle shake to ensure it's secure. If you hear any rattle, add a thin rubber washer or adhesive foam tape between the frame and the vehicle body. Confirm the plate is straight and not obstructing any sensors or lights. A quick test drive will confirm there are no vibrations.

Product Facts

REMARK License Plate Frame: REMARK License Plate Frame Black with White Logo, designed to match vehicles with REMARK exhaust systems. This frame gives your car a coordinated, finished look when paired with your REMARK exhaust, and the black finish hides dirt and grime well.
REMARK License Plate Frame