Quick answer
Installing the Bold Performance cat-back exhaust on your 2024+ Toyota Tacoma is a straightforward bolt-on job that takes about an hour with basic hand tools.
What you need to know before starting
The Bold Performance cat-back system uses 304 stainless steel and mandrel-bent 2.5-inch piping, so it's heavier than a stock aluminum system. Have a helper or a jack stand ready to support the muffler during removal.
The tucked muffler design improves ground clearance, but it also means the hangars are tight. Use penetrating oil on the rubber hangers to avoid tearing them.
Installation steps
- Prepare the vehicle: Park on a level surface, let the exhaust cool completely, and disconnect the negative battery terminal. Apply penetrating oil to the flange bolts and rubber hangers. Skipping the oil makes bolt removal much harder, especially if the car has any mileage.
- Remove the stock exhaust: Unbolt the flange at the engine-side of the cat-back (two 14mm nuts). Support the muffler, then cut or stretch the rubber hangers off the stock hanger pins. Slide the old system out from under the car. If the hangers are stubborn, use a pry bar gently; tearing them leaves you without a way to hang the new system.
- Transfer the hangers to the new exhaust: Slide the rubber hangers onto the Bold Performance hanger pins. Apply a thin coat of anti-seize to the flange bolts. The hanger pins are welded on; don't try to remove them. Line up the hanger slots before tightening.
- Install the new exhaust: Position the Bold Performance cat-back under the car, attach the flange with the two 14mm bolts, and hand-tighten. Then hook the hangers onto the chassis pins, starting from the front. Tighten the flange bolts evenly to avoid a leak. A common mistake is overtightening—torque to 30 ft-lb max.
- Check clearance and tighten everything: Rock the exhaust gently to ensure it doesn't contact the chassis or driveshaft. Then torque the flange bolts to 30 ft-lb and secure all hangers. Reconnect the battery and start the engine to check for leaks. If you hear rattling, the muffler can may be too close to the crossmember. Loosen the hangers, shift the system slightly, and retighten.
Product facts
- Bold Performance - Toyota Tacoma [2024+]: Complete bolt-on cat-back exhaust system with 304 stainless steel construction, mandrel bent 2.5-inch piping, and straight-through muffler design. The stainless steel resists corrosion longer than aluminized steel, and the straight-through design gives a sporty tone without excessive drone.
![Bold Performance - Toyota Tacoma [2024+]](/uploads/sites/7011/import-1790100006158-672532463.jpg)
Bold Performance - Toyota Tacoma [2024+]


![Bold Performance - Toyota Tacoma [2024+]](https://remarkecp.com/api/image-optimizer?src=%2Fuploads%2Fsites%2F7011%2Fimport-1790100006158-672532463.jpg&w=800&q=86)